NOTES 

1) Controller X can be any MIDI controller. After pressing the red push button twice to 
   enter SET-UP mode, operate the required MIDI controller before pressing the C or Db key 
   that will assign it. If you do not operate a controller before pressing the C or Db key, 
   then controller X will respond to MIDI controller 16 - that is General purpose controller 
   1 (10 hexadecimal)

2) Controller Y can be any MIDI controller. After pressing the red push button twice to 
   enter SET-UP mode, operate the required MIDI controller before pressing the A or Bb key 
   that will assign it. If you do not operate a controller before pressing the A or Bb key, 
   then controller Y will respond to MIDI controller 17 - that is General purpose controller 
   2 (11 hexadecimal) 

3) Controller X/Y will take priority over other control messages, so if controller X/Y is 
   the mod wheel, mod wheel messages will operate whatever controller X/Y is currently 
   assigned to, instead of operating modulation. 

4) Transmit/Receive channel and omni-on setting will return you directly to playing mode, 
   all other keys will let you stay in SET-UP mode until you press the ENTER key (Top C) 

5) The ENTER key (Top C) also resets all controllers to their default values - off in 
   most cases - on for volume - centre for pitch bender. 

6) After pressing   the red push button twice to enter set-up mode, the first assignment 
   that you make for any given source (after-touch for example) will cancel all other 
   destinations currently assigned to that source - if you want to make multiple 
   assignments, you will have to do this in the same set-up session, in other words, before
   you press top C. - For example - irrespective of what aftertouch was previously assigned
   to, pressing F (and release) will assign it to VCF only - to make aftertouch also bend
   pitch, you will have to press E (and release) before pressing the top C which will ENTER
   the information and store it in n.v. memory. OTHER SET-UPS WILL REMAIN UNALTERED UNLESS
   SPECIFICALLY CHANGED 

7) Control change commands recognised - (numbers in decimal) 

   121 reset all controllers                  01 modulation wheel 
   123 all notes off                          07 Main volume 
   124 otnni mode off (always poly)           64 sustain pedal 
   125 omni mode on (always poly)             94 select transpose mode 
   126 (rnono mode) = all notes off           95 select set-up mode 
   127 (poly mode) = all notes off 
   nnn Controller X (user defined where nnn = any controller) 
   nnn Controller Y (user defined where nnn = any controller) 
   Controller X default = 16                  Controller Y default = 17 

8) Other commands recognized - (numbers in hexadecimal) 
   8nH notes off                              9nH notes on & velocity
   BnH control change (see above)             CnH program change 
   DnH channel pressure (aftertouch)          EnH pitch-bend change
   FEH active sensing                         F6H auto-tune request 

MIDI CONTROL OF RED PUSH BUTTON 

The red push button can be "pressed" via MIDI as MIDI switch number 95 (5Fh) for regular 
program mode or 94 (5Eh) for transpose mode. The selection of the push button is enough, 
it doesn't matter if it is being turned on or off. 

In hexadecimal BX - 5F - 00 = program mode 
In hexadecimal BX - 5E - 00 = transpose mode 
Where X is the current MIDI channel. 

[N B. whilst in program/transpose modes the MIDI is in omni on mode]